Assembly & Operation Manual
14. Install the hub (4) with barrier arms (3) in the following order:
Insert the hub into the appropriate mounting seat on the turnstile mechanism shaft.
Secure the hub with three screws with spring washers (5); preliminary, to fix the screws
securely, apply a bit of the supplied sealant to the bottom of their threads. Tightening the
screws should ensure reliable hub fixation relative to the turnstile mechanism shaft (without
backlash and distortions). The tightening force of the hub screws is 15Nm.
Caution!
For correct hub installation, before final tightening of the screws, it is necessary to supply
power to the turnstile, move the barrier arm to its horizontal position and use a square to
set an angle of 90° in a horizontal plane between the arm and the turnstile base.
Run a test switch on of the turnstile (Sect. 9.1).
8.5 Connection layout
Table 4. Connection layout description
Legend
Name
Q-ty
A1 Control
board
1
A2 Interface
board
1
A3 Drive
assembled
1
A3.1
Position sensor board
1
A3.2
Electric drive motor
1
A4
Blocking device optical sensors board
1
A5
LED indication unit
1
A6
“Anti-panic” device electric magnet
1
A7
Blocking device electric magnet
1
A8
1
Turnstile power supply (battery) 24V
1
A9
1
Siren DC 12V
1
A10
ACS controller
1
A11
1
RC-panel 1
A12
1
Emergency unblocking device
Fire Alarm
1
A13
1
WRC
1
A14
1
Intrusion detector
1
A15.1
1
, A5.2
1
Remote indicators for A and B directions (RI A, RI B)
2
A16
1
Remote indicator power supply
1
A17
1
Low battery indicator
1
1
CAN connection cable
1
2
The rotor position sensor connection cable
1
3 Indication
cable
1
4
Wire jumper if FA device is not installed (A12)
1
5
2
Wire jumper if intrusion detector is not installed (A14)
1
6
1
Turnstile power cable
1
Supplied on request.
The jumper is installed upon delivery.
24