PERCo TTD-03.1, Operation Manual

Page: 8 / 30

TTD-03.1 Electromechanical Box Tripod Turnstile
7
Control commands and corresponding indication on RC-panel for impulse and potential modes are
indicated in Table 2 and Table 3.
At the turnstile power supply switching-on the turnstile initial state is closed (the mechanical
release lock (8) should be locked with the key).
In the “Single passage in the set direction” mode the turnstile will close automatically after a
person’s passage in the set direction. The turnstile will also close automatically, if the passage is
not made within 5 sec. In the “Bidirectional single passage” mode after the passage in one
direction the countdown of the passage waiting time (5 sec) for the opposite direction is
recommenced.
The RC panel is connected to the CLB with a multicore cable via the "XT1.L"
connector block (see
Fig.13).
Fig. 3 RC-panel
1, 2, 3 – buttons LEFT , STOP , RIGHT for setting the passage mode;
4, 6 – green indicators
«Left»
,
«Right»
; 5 – red indicator
«Stop»
5.2.4 Control board
Turnstile control board (see Fig. 4) located inside the turnstile housing under the left-side outer
panel (2). It connects to: RC-panel, ACS controller outputs, WRC device, intrusion detector,
emergency unlocking device Fire Alarm. External devices are connected in accordance with the
turnstile electrical connection layout (see Fig.13).
On control board there is a microcontroller, which processes incoming control commands (inputs
"Unlock A", "Stop", "Unlock B" and "Fire Alarm"), traces the condition of barrier arms optical
sensors and basing on received data generates commands on control unit of the turnstile. Besides,
microcontroller generates signals on outputs: for indication on RC-panel (outputs "Led A",
"Led Stop" and "Led B"), for outer indication (outputs "Light A", "Light B"), for passing in a
corresponding direction ("PASS A" and "PASS B"), for turnstile readiness to run the command
("Ready"), for alarm ("Alarm"), to retransmit the signal of intrusion detector condition ("Det Out").
The CLB (see Fig. 4) contains:
• control mechanism connector – "X1" ("Control") (using the turnstile cable for connection to the
"X1" connector of the control mechanism);
• connector block for connection of the RC-panel / WRC / ACS controller inputs and the Fire
Alarm device — "XT1.L" ("In");
• connector block for connection of a siren and ACS outputs, providing the turnstile status data to
the ACS controller – "XT1.H" ("Out");
• intrusion detector connector block – "XT2" ("Detector");