Operation manual
16
2. Drill the holes for anchor bolt sleeves for fixing of the turnstile housing (see Fig. 10).
3. If you lay the cables under the floor surface, prepare the electric raceway to the cables laying
zone of the turnstile housing (see Fig. 10).
4. Insert the sleeves for the anchor bolts into the holes so that they do not stick out above the
floor surface.
5. Mount the turnstile housing and fix it with the
M10 anchor bolts.
To get an access to the mounting holes of the turnstile housing base remove the turnstile
cover (3) and both outer panels (2). Thus, you get an access to the mounting holes of the
turnstile housing base.
Fix the turnstile housing after laying the cables in the electric raceway
and inside the turnstile housing.
Fig.10 Hole pattern for the turnstile housing mounting
6. The cables layout inside the turnstile housing is shown in Fig. 11.
7. Install the turnstile power supply in its place (installation procedure for the turnstile power
supply is given in the power supply certificate).
8. Connect the power cable (10) of the turnstile power supply to the CLB “XT3” connector block.
Connect the RC-panel (9) cable to the CLB “XT1.L” connector block. Connect all the other
devices’ cables to the corresponding CLB connector blocks (see Fig. 4 and 13).
9. When you connect the emergency unblocking device, remove the jumper wire set between the
contacts Fire Alarm and GND of the CLB “XT1.L” (In) connector block.
10. If the turnstile is used in the potential mode, remove the jumper from the "J1" connector (see
Fig. 4).
11. Check serviceability and accuracy of all the electrical connections. Fasten all the cables using
self-adhesive wires retainers and fixed brace rods included in the delivery set. After all the
cable connections and the turnstile housing fixing to the floor put the outer panels (2) and the
turnstile cover (3) back into their places in the reverse order to the dismantling procedure.
12. To mount the turnstile cover (3) install it so that the middle strip on its under side is placed on
the side of turnstile cover lock (6). Connect the indication cables mounted inside the turnstile
housing to the indication module (4) connectors, after carefully install the turnstile cover on the
frame. At that the cross angle sections on the turnstile cover should be maximum close to
relative plug-in guides in the frame. Adjust the turnstile cover by moving it from right to left
against stop and after fix it by the turnstile cover lock. The turnstile cover lock is closed without
key by pushing it.
13. To mount the barrier arms into the run position, remove the cover from the hub (7) unscrewing
the screw. Unscrew the fixing bolt on the barrier arm (5). Fit the barrier arm into the mounting
hole on the hub and fasten it with the bolt. Put a spring washer under the bolt head. The bolts
must be tightened so as to provide reliable fixation of the barrier arms without a gap.
Repeat the above-described procedure for fitting up the remaining barrier arms.
Put the cover onto the hub and fix it with the screw.
