Assembly and Operation Manual
38
8.7.7 Installation and dismantling of side panels
There are two types of side panels – external (mounted on the sections on the outside of the
speed gate) and inner (mounted on the sections from the side of the passageway). Inner side
panels, unlike the external, have cut-outs for the sliding panels. Both side panels of the
STD-02
double-sided section are inner.
The side panels are fixed to the sections by means of spring hooks; the inner panel is additionally
fixed to the housing by two M3×8 screws with washers (installed by default, see Fig. 25). Align the
spring hooks on the panel into the corresponding slots of the section housing and carefully mount
the panel into its location until it stops. Check whether the hooks entered the slots around the
perimeter of the panel.
After installing the panels, check the uniformity of the gaps between them and the speed gate
housing, if necessary, the gaps can be adjusted by using the adjustment plates (see section 8.7.3).
Dismantling of the side panels needs to be done in the reverse order.
Figure 25. Installation of the side panels
