Installation
2
018-
11
11
3
Installation
3.1
Special Conditions of Use
■
The DPU must be mated with a suitably certified module, such as a TCU or PCU.
■
Connection of TCU/PCU and display shall only be made when de-energized.
■
The display does not pose an electrostatic discharge hazard under normal use
conditions. Use only a water damp cloth and allow to air dry for cleaning the device. Do
not use or install in high-charge areas. See IEC 60079-32-1 for further information.
■
In hazardous dust environments, regularly remove dust from the display unit to prevent
excessive temperature rise. See certificate for full information.
■
The device shall be installed such that risk of high-impact energy on display glass is
considered to be low.
■
The unit type DPU2100-* may only be used in connection with Fuchs computer
unit *CU1100-J1-* according to EU-Type examination certificate BVS 16 ATEX E 083X
for
ATEX applications or IECEx BVS 16.0060X for IECEx applications. It must be
properly
joined prior to being installed into a hazardous environment. See the system
manual for
full mounting details.
■
Power supplied from the TCU**00-* or PCU**00-* needs to be from a SELV or PELV
source.
3.2
General Installation Requirements
Observe the following requirements when installing the display unit.
■
The equipment must be installed by competent personnel in accordance with the
instructions. National laws and regulations must be observed.
■
The building installation must provide a 20 A overcurrent protection.
■
The installer must make a readily accessible disconnect device available.
■
The safety of any system incorporating the power supply unit is the responsibility of the
assembler of the system.
Note!
For detailed installation information, see the VisuNet IXD system manual.
Before installation, take into consideration the compatibility of the materials on
this device and the environment in which the device will be used.
