2
0
2
2
-1
0
60
Operation
5.6
Locating the Handheld Reader
The Page button on the charging cradle helps you locate a connected handheld reader. If it is
pressed for more than one second, the connected handheld reader beeps until any button on
the handheld reader is pressed. Please note that the handheld reader emits a beep via the
Page button, even if the beep function is deactivated. If a handheld reader is not connected, the
Page LED on the charging cradle flashes quickly three times.
The search function is automatically deactivated after 30 seconds.
5.7
Operating Modes
The handheld reader offers four operating modes:
Read mode
•
Press the trigger button on the handheld reader to read codes.
•
If motion detection is activated, the handheld reader automatically attempts to read a
code, as soon as a movement is detected in the read range.
Idle mode
The handheld reader is switched on, codes are not read. In this state , the lighting and the blue
bar are switched off.
Shutdown mode
If the handheld reader is not charged and is in idle mode, it will turn off by default after two
hours. The duration of the idle mode before entering the power-off mode can be set between
one and ten hours. If you press any button on a scanner that is turned off or place it in a charger
with power, it will wake up again within two seconds.
Note
Battery Status Check
The battery has a built-in status check that compares the remaining energy capacity to a new
cell. Depending on the intensity of use and operation, the battery should be replaced if the
remaining capacitance falls below a certain value to ensure that the battery always lasts a
whole shift. Code (M20402_01) recommends replacing the battery when the remaining
capacitance falls below 80 %, which is approximately 500 charge cycles.
