peplink PEPWAVE BR1 Classic User Manual Download Page 165

Page: 165 / 424

match. When the peer is running firmware 5.0+, this setting will be ignored.

Enter Remote IDs either by typing out each Remote ID and Pre-shared Key, or by
pasting a CSV. If you wish to paste a CSV, click the

icon next to the “Remote

ID / Preshared Key” setting.

Remote

ID/Remote

Certificate

These optional fields become available when

X.509

is selected as the Pepwave

MAX’s   VPN   authentication   method,   as   explained   above.   To   authenticate   VPN
connections   using   X.509  certificates,  copy  and  paste  certificate  details  into  these
fields.  To  get more information on a listed X.509 certificate, click the

Show Details

link below the field.

Allow Shared

Remote ID

When this option is enabled, the router will allow multiple peers to run using the
same remote ID.

NAT Mode

Check this box to allow the local DHCP server to assign an IP address to the
remote peer. When

NAT Mode

is enabled, all remote traffic over the VPN will be

tagged with the assigned IP address using network address translation.

Remote IP

Address / Host

Names

(Optional)

NAT Mode

is not enabled, you can enter a remote peer’s WAN IP address or

hostname(s) here. If the remote uses more than one address, enter only one of
them here. Multiple hostnames are allowed and can be separated by a space
character or carriage return. Dynamic-DNS host names are also accepted.

This  field  is optional. With this field filled, the Pepwave MAX will initiate connection
to  each  of  the remote IP addresses until it succeeds in making a connection. If the
field   is   empty,   the   Pepwave   MAX   will   wait   for   connection   from   the  remote  peer.
Therefore,   at  least  one  of  the  two  VPN  peers  must  specify  this  value.  Otherwise,
VPN connections cannot be established.

Cost

Define path cost for this profile.
OSPF will determine the best route through the network using the assigned cost.
Default: 10

Data Port

This field is used to specify a UDP port number for transporting outgoing VPN
data. If

Default

is selected, UDP port 4500 will be used. Port 32015 will be used if

the remote unit uses Firmware prior to version 5.4 or if port 4500 is unavailable. If

Custom

is selected, enter an outgoing port number from 1 to 65535.

Click the

icon to configure data stream using TCP protocol

[EXPERIMENTAL].In the case TCP protocol is used, the exposed TCP session
option can be authorised to work with TCP accelerated WAN link.

Bandwidth Limit

Define maximum download and upload speed to each individual peer. This
functionality requires the peer to use PepVPN version 4.0.0 or above.

WAN Smoothing

While   using   PepVPN,   utilize   multiple   WAN   links   to   reduce   the   impact   of   packet
loss   and   get   the   lowest   possible   latency   at   the   expense   of   extra   bandwidth
consumption.  This  is  suitable  for  streaming applications where the average bitrate
requirement is much lower than the WAN's available bandwidth.

https://www.peplink.com

165