128
U
s
ing
the
Flas
h
5
Compensating Flash Output
You can change the flash output in a range of –2.0 to +1.0. The flash
compensation values are as follows for 1/2 EV and 1/3 EV.
* Set interval of steps in [1. EV Steps] (p.101) in the [
A
Custom Setting] menu.
Set the flash compensation value by turning the e-dial in the [Flash Mode]
screen in the Fn menu (p.77).
Step interval
Flash compensation
1/2 EV
–2.0, –1.5, –1.0, –0.5, 0.0, +0.5, +1.0
1/3 EV
–2.0, –1.7, –1.3, –1.0, –0.7, –0.3, 0.0, +0.3, +0.7, +1.0
• If the maximum flash output is exceeded when corrected to the plus (+) side,
no compensation will be effective.
• Compensating to the minus (–) side may not effect the image if the subject is
too close, aperture is low or sensitivity is high.
• This flash compensation is also effective for external flash units which
support P-TTL auto flash mode.
• Pressing the Green button on the [Flash Mode] screen resets the flash
exposure compensation to the default setting [0.0].
0 . 0
0 . 0
0 . 0
Flash Mode
Flash Mode
Auto discharge
Auto discharge
Flash Mode
Auto discharge
O K
O K
O K
OK
Summary of Contents for 19541
