7
RACER
®
LS Pressure Side Pool Cleaner Installation and User’s Guide
ENGLISH
Installing and Removing the Sweep Hose
The Racer
®
LS Pressure Side Pool Cleaner comes from the
factory with a Sweep Hose Cap installed over the Sweep
Hose Connection (see
Figure 14
). This cap blocks flow
through the sweep hose connection when the sweep hose
is not being used.
1. To remove the sweep hose cap, while pushing the sweep
hose cap in towards the cleaner, turn it 1/4 turn counter-
clockwise to unlock. Remove the cap from the sweep
hose connection by pulling is straight off the sweep hose
connection.
2. Line up the lock tabs on the inside of the sweep hose
fitting (small round fitting on the end of the sweep hose) to
the locking slots on the cleaner’s sweep hose connection.
See
Figure 15
.
3. Push the sweep hose fitting onto the sweep hose
connection and turn clockwise until it stops (about 1/4
turn). Pull the sweep hose fitting away from the cleaner
to lock it into place.
4. To remove the sweep hose, while pushing the sweep
hose fitting towards the cleaner turn counter-clockwise
until it stops (about 1/4 turn).
Pull the sweep hose from
the sweep hose connection and store it in a safe place.
Locking
Slot
Sweep Hose Connection
Lock Tab
Sweep Hose Fitting
Figure 15
Sweep Hose
Connection
Sweep Hose
Sweep Hose
Scrubber
Figure 13
Sweep Hose
Cap
Figure 14
