JET-VAC INSTALLATION MANUAL
4
IMPORTANT WARNINGS
1. ALWAYS remove the JET-VAC Automatic Pool Cleaner before anyone enters the swimming pool.
2. ALWAYS have a
licensed electrical contractor install the wiring for the JET-VAC Booster Pump. It must
be wired in accordance with a local and/or regional electrical codes.
3
ALWAYS disconnect the JET-VAC from the wall when back-washing or cleaning the filter system. When
you have finished and the pumps are OFF, remove the wall fitting first, then turn ON the filter pump. WAIT
ONE MINUTE, then turn ON booster pump to flush out the sweep line. Then turn OFF booster pump
AND filter pump. Remove and thoroughly clean filter screen inside wall fitting. Reassemble screen into
wall fitting and screw fitting back into wall. Adjust wall fitting so that the connector points up towards the
water surface.
4. ALWAYS remove wall fitting and JET-VAC when back-washing filter system. Be certain wall fitting screen
is clean before reinstallation.
5. ALWAYS remove JET-VAC and hoses when adding chemicals. Run filter to mix chemicals in water for at
least 30 minutes before reinstalling JET-VAC and hoses in water. CHEMICAL ATTACK WILL VOID THE
WARRANTY. Never pour concentrated chemicals on or near any part of the JET-VAC or hose assemblies.
6. ALWAYS store all parts of the JET-VAC and hose assemblies away from excessive heat or cold and
direct sunlight, when not in use.
7. The JET-VAC is not designed to clean up after new pool construction. Large amounts of grit or sand will
damage wheel bearings. Please manually vacuum the pool before installing the JET-VAC.
8. NEVER operate your JET-VAC without a booster pump. Your existing filter system cannot generate
adequate pressure.
