Installer Manual Performa 263-268 / LOGIX 740-760 - Maintenance
Ref. MKT-IM-011 / A - 15.06.2017
49 / 64
9.2.8. Optical sensor and controller replacement
No.
Operation
Note
To remove the optical sensor, you first have to disassemble the camshaft. See “Motor and
camshaft replacement”, page 48.
A
The optical sensor (
2
) is clipped on the front edge, gently press on the clips to release the
optical sensor (
2
) from its location.
B
Press the controller locking pad (
4
) and slide the controller (
3
) out of its position.
C
Disconnect the cables from the controller by pressing on the clip and pulling them.
D
Remove the motor, cables and optical sensor assembly to change them.
E
Reverse above procedure steps to rebuild.
Caution
When refitting, always use the cables guide (
1
) to secure the cables. This will prevent the
cables from being crushed or cut when closing the cover or by the camshaft during
regeneration cycles.
A
A
