Pentair AQUATRAM 90, Installation And User Manual

Page: 16 / 24

TROUBLESHOOTING GUIDE
Before troubleshooting make sure the battery is fully charged.
If the AquaTRAM
®
90 Swimming Pool Access Lift doesn’t move when the
handset button is pressed:
When you can’t get the lift to move check the following things:
1. Make sure the battery is fully charged:
A. Before charging the battery first make sure the green light on
the front of the charger is illuminated (this means that the
charger is on). Then check to make sure the silver contact
points on the battery and charger are not damaged or corroded,
and that they are clean. Then place the battery on the charger
and look for the
orange charge light to illuminate on the front of
the charger. When the orange light goes off the battery is fully
charged.
B. When the battery is correctly installed on the charger or control
box you should hear a “click” indicating the battery is properly
seated on the unit. Also note that when the battery is properly
seated there should not be any gaps between the battery and
the control box/charger.
The top green light will always
be illuminated indicating that it
has power. When charging the
battery the bottom
orange light
will illuminate, until fully
charged.
Not attached properly. Note
the white bracket is in front of
silver clip, which will not allow
for an electrical connection.
Properly Attached.
Note that the white bracket is
behind the silver clip. Not allowing
movement.
15