Rev. A • Rev. A • Rév. A 6-5-01
7
P/N • Núm/Pte. • Réf. P/N 619408
A
Bolt and nut are to be tightened at approx. 45 degrees
from the pilot screw between the tabs on the face ring
as shown above.
45 degrees
Figure 4.
Figure 5.
Item
No.
Part No.
Description
1
79213100
Face ring, large plastic, snap-on, white
1
79213165
Face ring, large plastic, snap-on, gray
1
79213111
Face ring, large plastic, snap-on, black
2
79104800
Pilot Screw, with captive gum washer
3
79110600
Face ring assembly, S/S
4
79110400
Wire, uni-tension
5
79112000
Bolt
6
51008500
Washer
7
98216100
Nut, brass
8
79111000
Uni-tension wire clamp assy.
9
79100100
Lens,
S
Am
, 8-3/8 in. dia., tempered
10
79101600
Gasket, 8-3/8 in. lens
11
79112400
Bulb, 75 watt, EYC, MR-16
NOTE
120V
S
Am
's have and integral 12V transformer.
All
S
Am'
s use 12V lamp.
1
2
3
4
5
6
7
8
9
10
11
Section VII.
Spectrum Amerlite (SAm) Replacement Parts.
SAVE THESE INSTRUCTIONS.
Section VI. Stainless Steel Face Ring Assy. Instructions.
1. Replace lens gasket. A NEW LENS GASKET MUST BE
USED EACH TIME THE LIGHT IS REASSEMBLED.
2. With the light resting on its base, place lens/gasket
assembly on light fixture and position so the white pointer
on the color wheel/bulb assembly points to the "O" in the
word "TOP" on the surface of the lens. See Figure 2.
3. Align the special pilot screw on the face ring with the
letter "O" of the word "TOP" on the surface of the lens.
The pilot screw, "O" in "TOP" and the white pointer on the
color wheel/bulb assembly should also align with the cord
compression fitting on the top rear of the light fixture.
4. With the bent ends of the circular uni-tension clamp
pointing down spread the clamp and place it in the “U”
recesses of the locking levers. Be sure the bent ends of
the clamp are located between the pair of locking levers as
shown in Figure 4, location A. Check to see that the clamp
is properly engaged with all of the levers.
5. Turn the light so that it is now resting on its lens. Tighten the screw and nut until the distance between the ends of
the clamp equals 1/4 inch or less; see Figure 5.
