LEGEND® INSTALLATION MANUAL
III. Operation/Periodic Maintenance
A. Connecting/Disconnecting the
Legend
®
Turn off the booster pump and pool pump. Then take
the Wall Fitting and twist lock the Wall Fitting
clockwise into the Wall Adapter. To disconnect the
Legend
®
, unlock and twist counter-clockwise. The
Wall Adapter should remain in the pool wall.
B. Turning On/Off the Legend
®
The Legend
®
operates off the booster pump coming
from the equipment pad, and can be turned on or off
by merely turning on/off your booster pump time
clock.
C. Cleaning the Sand & Silt Bag
Carefully unlock the debris bag from the vacuum
tube. Use your thumb to push the "U" shaped snap
lock closure upward until it snaps open. Make sure
to swing it away from the opening. Open the bag and
remove debris.
If you have any additional questions, please
contact Pentair Water Pool and Spa, Inc.,
Technical Support Department at:1-800-831-7133,
Monday through Friday.
G. Fine Tuning the Legend
®
3. Checking Wheel RPM
To determine whether the Legend
®
is receiving the
proper water pressure, turn off the pool pump, and
carefully remove the Legend
®
from the pool.
8
Mark the front drive Tire/Wheel with a marker, or
use the Pentair logo located on the side of tire as a
marker to count the rotations of the wheel per minute.
Have someone turn on pool pump and the booster
pump while you place the Legend
®
in the pool just
beneath the water surface. (Be sure to hold onto
the Sweep Hose to avoid getting wet).
Count the rotations of the marked wheel for exactly
one minute. (Be sure the Back-Up Valve isn't cycling
at this time). The rotations will give you the
Revolutions Per Minute. (RPM)
For proper performance, the Legend
®
operates
between 28-32 RPM. If the RPM is below 28 then
call your local Pool Professional or contact our
Technical Support Department at 1-800-831-7133.
If the RPM is more than 32, at the Wall Fitting, unscrew
the Pressure Relief Valve slowly until the RPM falls
between 28-32.
SWEEP
HOSE
FRONT
WHEEL
DRIVE
Push middle of
the bag inward
for closure.
OPEN
CLOSE
CLEANER BAG
"U" SHAPED
SNAP LOCK
CLOSURE
OPE
N
OPE
N
To close, push the middle of bag inward, as shown,
and bring the edges together to make them stack like
an accordion. Swing the "U" shaped snap lock
closure back to the closing position.
