7
1. Turn off booster pump, filter pump and time clocks.
2. Attach the wall fitting to the pool wall.
3. Attach the "Sweep Hose" end of the feed hose to the wall
fitting. (Hereafter,
attached
refers to
attached to the wall
fitting).
See
Photo #1.
4. With a loose grasp on the feed hose, walk around the
circumference of the pool to find the point that is furthest
from the wall fitting and remove slack from the hose,
but
do not stretch the hose.
See Photo #2
5. While maintaining a grasp on the attached hose, use a
sharp knife to cut the dark blue hose (marked with a
bright-colored label reading "cut this section only") at the
point where the end of the hose would touch the edge of
the pool. See
Photo #3.
Take both hose sections and go
to the wall fitting.
*Note: After you cut the dark blue hose to size, evenly
space the two JV57 float moving them so they divide the
remaining section into three equal parts.
6. Secure with your foot or knee the dark blue attached
hose. Remove the dark blue piece of hose from the white
section at the mender nut and discard the severed piece
of dark blue hose.
7. At the mender nut, attach the removed white hose to the
severed end of the attached dark blue hose. See
Photo
#4
8. Reverse hose ends (disconnect the sweep hose end of
the hose from the wall fitting and reconnect the other
white hose end to the wall fitting).
Photo #2
Photo #3
Photo #4
JETVAC
®
INSTALLATION MANUAL
Photo #1
®