S E T T I N G U P Y O U R B I K E
BIKE PL ACEMENT
•
Place the bike on a solid, level and
horizontal surface
•
Use a mat to avoid damage to the bike
and floor
•
Allow a clearance of 24” (60 cm) on each
side of the bike
MOVING THE BIKE
•
Tilt the bike forward onto the wheels.
Lift the rear stabiliser while a second
person holds the handlebars
•
Carefully roll the bike to the new location.
Avoid uneven surfaces
•
If the bike rocks after being set down,
unscrew each levelling foot until it rests
firmly on the floor
8
9
SEAT DEPTH
Set the seat depth so that the distance between seat
and handlebars is equal to the distance between your
elbow and fingertips.
•
Turn L-handle counterclockwise to loosen
•
Move seat forward or back
•
Turn L-handle clockwise to tighten
SEAT HEIGHT
Set the seat height to line up with the top of your
hip bone.
•
Turn L-handle counterclockwise to loosen
•
Raise or lower seat
•
Turn L-handle clockwise to tighten
24"
24"
24"
24"
CAUTION
To prevent injury, always adjust seat and handlebars to your personal requirements.
Tighten all adjustment handles before using the Peloton Bike. Projecting adjustment handles could interfere
with your movements. Do not exceed maximum adjustment marks on seat and handlebar posts and sliders.
If any adjustment handle sticks out sideways, pull the handle out, rotate it to point down, and then release it.
CAUTION
The Peloton Bike has a direct driven flywheel; the pedals will continue to move until the flywheel stops.
Reduce speed slowly. To stop the flywheel immediately, push down the resistance knob.
