5
Check before turning on the machine
1. Check if the power wire is under good condition.
2. The product adopts 120V AC power supply, before use, please confirm if
the rated current of the power socket meets the local requirements with safe
grounding device, otherwise, please replace it with the qualified socket.
Start the machine
Plug the unit into a grounded 120V outlet, press the ON/OFF key (or press the
ON/OFF key of the remote controller) for start, the machine supplies air at high
power after start,the display will show the temperature of 95°F.
Function setting
Repeatedly press the "Function" key so that the heater switches in the order of
"high gear - low gear - fan - ECO mode - high gear".
Temperature setting
In the working state of the machine, press "+" or "-" can set the temperature
value, set the range of 41-95°F.When the room temperature reaches the set
temperature, the display flashes 10S, the machine stops working. In the standby
state, when the temperature is lower than the set temperature, the machine
starts to heat up again.
Timing function
Timing stop
When the heater is turned on, press the TIMER key to enter the timing stop
state (within 0-24 hours), then press the “+” key to increase the timing stop time
by 1 hour once, and press the “-” key to decrease the timing stop time by 1 hour
once.
Timing start
When the electric heater is in the standby mode, press the TIMER key to enter
the reservation start mode (within 0-24 hours), then press the “+” key to increase
the reservation start time by 1 hour once, and press the “-” key to decrease the
reservation start time by 1 hour once.
Swing function
The electric heater in operation mode, press the "swing" key to open the swing
function, pressing this button to turn off the swing function; when the electric
heater stops heating function, the wind swinging function also stop.
memory function
Machine after normal shutdown, restart, will be in accordance with the recent
shutdown before the state run.
Power off, once again, in accordance with the factory default values. high gear
start. Set temperature by default to 95°F.
Off screen function
Machine in the working state, 1 minutes without operation, the screen
automatically goes out, only to keep the heating logo lit. While holding the "+"
and "-" button for 2 seconds, you can turn off the screen function, once again
hold the "+" and "-" button for 2 seconds, turn off the screen function.
Temperature sensor short circuit, open circuit protection
function
No matter in what mode, the temperature sensor appears short circuit
protection, digital screen display room temperature digital tube display E1 or E2
and constantly flicker, any key operation is invalid. The buzzer ringing 10 times.
Safety protection
In the start state, when the room temperature TH is above 122 °F, close all
outputs system, The digital screen displays "FF" and flashes 1 times per
second at a frequency of 75 times, press any key will not work, only the power
down to exit the protection.
ECO energy saving function
Select the ECO energy saving gear, electric heater according to the ambient
temperature and the temperature setting of the machine to do comparison,
select the appropriate gear operation to achieve the purpose of saving energy.
Remote controller
Use of the remote controller: the key functions are basically the same as the
body operation panel.
