PELLA
®
INSYNCTIVE
®
INTEGRATED ENTRY DOOR SENSOR PRODUCT GUIDE
|
6
To sync OPEN/CLOSE SENSOR to BRIDGE, open then close your
entry door twice within 5 seconds.
Wait for the light on BRIDGE to flash green and beep for 2
seconds. This will indicate a successful sync.
If OPEN/CLOSE SENSOR sync is unsuccessful, return to Step 2
and retry the process.
4. Prepare LOCK SENSOR
Use a small flathead screwdriver to remove the battery cover
on LOCK SENSOR. Carefully remove the battery with the flathead
screwdriver.
Remove the plastic tab separating the battery from LOCK
SENSOR. Ensure the battery is properly installed. Replace battery
cover on LOCK SENSOR.
NOTE:
Once the plastic tab is removed from the battery, you
will have 2 minutes to sync your LOCK SENSOR to BRIDGE. If 2
minutes pass without successfully syncing, remove and insert the
battery again.
You are ready to sync LOCK SENSOR to BRIDGE.
5. Sync LOCK SENSOR to BRIDGE
Each INTEGRATED ENTRY DOOR SENSOR will need to be
synced to BRIDGE.
WITHOUT HOME AUTOMATION (Stand-Alone Mode)
Press and hold BRIDGE Sync button until light begins flashing
orange. The Sync button is the bottom button located on the
side of BRIDGE.
DETAILED INSTRUCTIONS
(continued)
LIGHT
SYNC
BUTTON
TEST
BUTTON
BRIDGE
LOCK
SENSOR
BATTERY
COVER
BATTERY
BATTERY
COVER
