PELLA
®
DESIGNER SERIES
®
BETWEEN-THE-GLASS BLINDS AND SHADES WITH INSYNCTIVE
®
TECHNOLOGY
|
9
TILTING BLIND SLATS
• To enter tilt mode, press and hold the Center button on
REMOTE until light turns solid red.
• Press and release the Up button to rotate the slats up.
• Press and release the Down button to rotate the
slats down.
• REMOTE will exit tilt mode after 10 seconds of no activity
or when Center button is pressed and held until the light
turns off.
SYNCING TO PELLA
®
INSYNCTIVE
®
BRIDGE FOR CONTROL
THROUGH YOUR SMART DEVICE
Ensure that BRIDGE is enrolled in the home automation
network. See Bridge Product Guide for complete
information.
To sync BLIND or SHADE to BRIDGE:
• Touch the top end of REMOTE to BLIND or SHADE cover
approximately 6" from the end where the wire connects.
Move REMOTE back and forth slowly until BLIND or
SHADE completes a quick up/down motion to indicate
BLIND or SHADE has entered sync mode.
• Press and release the Center button on REMOTE three
times within 5 seconds. BRIDGE light will begin blinking
blue. If light does not begin blinking blue, additional
button presses may be required due to the range
between BLIND or SHADE and BRIDGE.
• Follow the inclusion process for the Z-Wave home
automation system to add BLIND or SHADE to the system.
BLIND or SHADE will complete a quick up/down motion
to acknowledge BLIND or SHADE was successfully added
to the home automation system.
• If BLIND or SHADE does not cycle to the top, press and
hold the Up button for about five seconds. BLIND or SHADE
should then make a quick up/down motion and move to
the top.
DETAILED INSTRUCTIONS
(continued)
LIGHT
SYNC
BUTTON
TEST
BUTTON
UP
BUTTON
DOWN
BUTTON
LED
LIGHT
CENTER
BUTTON
UP
BUTTON
DOWN
BUTTON
LED
LIGHT
CENTER
BUTTON
COVER
REMOTE
MEASURE 6"
FROM END WHERE
WIRE CONNECTS
BRIDGE
