Pelican PRC34 Whole House Filter/Softener Combo
Rev
A
Page
16
© 201
7
Enviro Water Solutions LLC
3060 Performance Circle, Suite 2. DeLand, FL 32724
www.pelicanwaterretail.com
NaturSoft
Media Flush/Condition
1. After the tank has soaked for 60 minutes, turn the main water supply back on or turn the Bypass
Valve back into the original position.
2. Flush the system by running water for 5 minutes at a high flow rate of 5 GPM (this can be
achieved by using a bath tub or more than 3 faucets).
Note:
The flush water may have a milky look to it. This is normal as calcium carbonate fines are
flushed from the system.
3. Rinse the system by reducing the flow rate to ½ GPM and run water for 60 minutes (this can be
achieved by turning one faucet ¼ of the way on).
NaturSoft
®
Media Soak
1. Open a cold water faucet downstream of the Water Softener.
2. Turn the water back on at the main shut-off valve allowing the system to fill with water. The air
being displaced will escape through the open fixture downstream.
3. Fill the NaturSoft
®
Tank full until water comes out of the downstream fixture. Bypass the tank
using the bypass installed around the system. This will allow you to isolate the system and restore
water supply to the home/building during the media soak.
4. Allow the tank to soak for at least 60 minutes.
