If one of program monitor lights is on and start/Pause light is on and off,
Your machine’s door is open, shut the door.
If the programme won’t start
•
Check if the plug is connected.
•
Check your indoor fuses.
•
Be sure that the water inlet tap is turned on.
•
Be sure that you have closed the machine door.
•
Be sure that you switched off the machine by pressing the Power On / Off button.
•
Be sure that the water inlet filter and the machine filters are not clogged.
If the control lamps won’t go out after a wash operation
The
Power On/Off
button is released yet.
If detergent residues are left in the detergent compartment
Detergent has been added when the detergent compartment was wet.
If water is left inside the machine at the end of the programme
•
The water drain hose is clogged or twisted.
•
The filters are clogged.
•
The programme is not finished yet.
If the machine stops during a wash operation
•
Power failure.
•
Water inlet failure.
•
Program can be on standby mode.
If shaking and hitting noises are heard during a wash operation
•
Dishes placed incorrectly.
•
Spray arm hitting the dishes.
If there are partial food wastes left on the dishes
•
Dishes placed incorrectly into the machine, sprayed water did not reach related places.
•
Basket overly loaded.
•
Dishes leaning against one another.
•
Very small amount of detergent added.
•
An unsuitable, rather weak wash programme selected.
•
Spray arm clogged with food wastes.
•
Filters clogged.
•
Filters incorrectly fitted.
•
Water drain pump clogged.
If there are whitish stains on the dishes
•
A very small amount of detergent is being used.
•
Rinse aid dosage setting at a very low level.
•
No special salt is being used despite the high degree of water hardness.
•
Water softener system setting is at a very low level.
•
Salt compartment cap not closed well.
30
