Pelgrim GVW360L, Operating Instructions Manual

Page: 165 / 174

Table continued from last page
Action Possible causes Problem
Press and hold the left
navigation button and the Auto
Open option button until the
display starts flashing. Wait until
it stops flashing (60 seconds).
Close the door. Check that the
door lock clicks into place and
locks.
Press and hold Start/Stop until
the display shows "Program
started, close door". The Start/Stop start button has
been pressed for too short a
time. The dishwasher does not start.
Check. The door is not properly closed.
Close the door and wait. After
a while, the dishwasher contin-
ues the program. You have opened the dishwash-
er to add more dishes while a
program is in progress.
Check the door lock. If it has
not clicked into place and
locked, open the door. The door lock has not clicked
into place and locked.
Press and hold the left
navigation button and the Auto
Open option button until the
display starts flashing. Wait until
it stops flashing (60 seconds).
Close the door. Check that the
door lock clicks into place and
locks.
Check. A fuse/circuit breaker has been
tripped.
Check. The plug is not plugged into the
wall socket.
Check. The water tap is turned off.
Check. Overflow/leaks.
Turn off the water tap. Pull out
the plug and call the service
department. A whirring sound (the drainage
pump) is heard from the dish-
washer and does not stop when
the main power switch is turned
off.
Press and hold Start/Stop for
three seconds if you want to
cancel the Delayed Start option. Check that the Delayed Start
option has not been selected.
Check that the dishes are not
blocking the spray arms. The spray arms do not rotate. The dishes are not clean.
Clean the spray arms. See the
chapter Care and cleaning. Spray arm holes or bearings
blocked.
33