Warning:
The warnings, cautions, and instructions discussed
in this instruction manual cannot cover all possible
conditions and situations that may occur. It must
be understood by the operator that common sense
and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure that the item
is intact and undamaged. If any parts are missing
or broken, please contact the seller.
Assembly
1. Attach each Side Frames (2#) to the Base (1#)
using Washers (7#),Lock Nuts(8#),and Socket
Head Screws (12#). see Figure 1.
2. Set the Axle (4#) onto the Bearings (9#). see
Figure 2.
Operation
1. Prior to use check to make certain that the Axle
is straight, without any bends or damage.
2. Back off both Socket Set Screws (11#) and
slide off one of the Centering Cones (5#) from
Axle (4#). Support the wheel of the motorcycle
in an upright position and slide the Axle (4#)
through the wheel hub and replace the Cone.
Center the wheel on the Axle and slide both
Cones securely against the hub.Tighten the
Socket Set Screws (11#).
3. Lift the wheel and position the Axle over the
Bearings (9#). Gently spin the wheel. The hea
-
vier side would roll to the bottom. With a chalk
mark the tire at the upper most location (across
from the heavy side).
4. Lift the wheel assembly from the stand and
place on the floor.Attach a balancing weight
(not supplied) to the inner edge of the rim and
reposition the wheel assembly over the
Bearings (9#).
NOTE: Use lightest possible weights. With try
and error, you should be able to establish
approcimate required weights.
5. Gently spin the tire. Repeat steps 3 and 4
placing balancing weights on alternative sides
of the tire rim.
6. Continue to counter balance the wheel until it
spins evenly and does not repeatedly stop at
any specific point of its rotation.
7. Once the wheel is balanced, remove the
assembly and place on the floor, back off one
Socket Set Screw(11#) and remove the Centing
Cone (5#). Remove the Axle,replace the Cone
and tighten the screw. Place the axle on the
Bearings (9#).
Part No.
Description
QTY
1
Base
1
2
Side Frame
2
3
Mounting Plate
2
4
Axle
1
5
Centering Cone
2
6
Sleeve
4
7
Washer 8
4
8
Lock Nut M8
8
9
Bearing
4
10
Socket Head Screw
M8X25
4
11
Socket Set Screw
M6X12
2
12
Socket Head Screw
M8X20
4
13
Wrench S=6
1
14
Wrench S=3
1
