User’s manual
12
EN
MOuNtiNg
Rear view camera installation
Prior to installation, select and mark suitable location. If possible, and tape off
the area to be drilled with masking tape in order to protect the surroundings. The
camera (1) should be located in a place that provides:
1.
proper field of view, with no parts of the vehicle within its sensing area which in
turn could disturb their operation.
2. the camera axis should be parallel to the surface of the road surface
3. before drilling the holes in vehicle’s body, make sure to select location in which
you will not damage any electrical cables, brake system, fuel tank etc.
4. before drilling a hole, determine the best way to run the cables through the
vehicle. Ensure the cables does not interfere any safety equipment nor reduce
safety of the vehicle.
DOUBLE CHECK BEFORE YOU DRILL! Look out for cables, sensors, lines,
anything that could get damaged.
5. After drilling, remove any burs or sharp edges so you do not damage the cable
when pulling it through.
6. Carefully route the camera’s cables through the hole.
7. Connect the red cable (2) protected with a fuse to power (+12 V) eg. reverse
light. Make a permanent connection using a crimp connector or by soldering etc.
8. Connect the camera’s cable to the rearview mirror (3) with AV cable (4).
9. Adjust the lens and keep the lens parallel with the ground.
10. Turn on the vehicle's engine and switch on reverse gear.
