GB
www.ptcarphone.de
15
Assembly instructions
&
installation
Sequence of installation
Familiarise yourself with the wiring diagram
(page
13
). unclip the negative pole of the vehicle
battery, while observing the safety instructions
of the vehicle manufacturer.
Select places for installation and install the elec-
tronics box, handset, loudspeakers, hands-free
microphone and antenna(s) taking into account
the cable lengths and installation instructions.
When drilling holes make sure that no vehicle
parts become damaged. use cable bushings whe-
re holes have sharp edges.
Install the hands-free microphone Me
15
in ac-
cordance with the „Microphone installation“. the
optimum distance from the mouth is approx.
30
cm. Airflows from the ventilation should not go
towards the microphone (see also „Places to In-
stall Microphone“). then install the loudspeaker
(the best position is in the lower front passenger
footwell). When installing the microphone and
loudspeaker, make sure that they are sufficiently
far apart to prevent an acoustic short-circuit.
In an especially loud environment the Me
251
(directional gooseneck microphone) from our ac-
cessories range can also be used.
connect the electrical supply cable (red cable) to
permanent positive and the ignition input (yel-
low/black) to the ignition. Do not place the igni-
tion input (yellow/black) on permanent positive,
as this would restrict the device’s functional ran-
ge (see page
14
„run-down time“).
the earth cable is connected directly to the vehic-
le battery, the central earth point (earth block) or
a part of the vehicle body. the earth connection
must be protected with the S
3
fuse included in
the scope of supply.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
connect the violet cable to the mute output of
your car radio. this ensures automatic radio mu-
ting during incoming or outgoing calls.
Insulate unused cables so that no short circuits
can occur.
connect the individual components of the de-
vice via plug and screw connections with the
plugs on the vDa cable and the electronics box.
check the overall installation and insert a valid
SIM card. connect vehicle battery and switch on
ignition.
the device now switches on and requests a PIN
(if this present response has not already been
switched off on the SIM card).
enter the PIN. the telephone now registers its-
elf in the network.
Make a call to test the basic functions of the
device.
Make any personal adjustments to the device
and complete the installation.
