nano LINE
200NANO4CK13 / 14
PEGO S.r.l.
Via Piacentina, 6/b - 45030 - ROVIGO
Tel : +39(0)425 762906 - Fax: +39(0)425 762905
www.pego.it - e-mail: [email protected]
200NANO4CK13-14_01-19_ITA_ENG # Rev.01-19 # 25/03/2019
GENERAL INFORMATION
PEGO S.r.l. does not accept responsibility for any loss of data or information, costs of goods or substitute services, damages to objects, persons or animals, lost sales or profits, interruption of activities, any direct, indirect,
accidental, property, insured, punitive, special or consequential damage caused in any way, be it contractual, extra-contractual or due to negligence or other responsibility resulting from the use of the product or its
installation. The guarantee automatically becomes invalid in the case of poor functioning due to tampering, impact or inadequate installation. It is mandatory to observe all instructions in this manual and the operating
conditions of the device. PEGO S.r.l. does not accept responsibility for any inaccuracies which may be present in this manual in the case that these are due to printing or transcription errors and reserves the right to make
modifications to its products which it deems necessary or appropriate, without prejudicing the products essential characteristics.
ELECTRICAL PRESCRIPTIONS
Avoid using multipolar cables with conductors connected to inductive and power loads and signal conductors such as probes and digital inputs. Avoid installing in the same channels power cables and signal cables
(probes, digital inputs or RS485 connections). Reduce to a minimum the length of the connecting cables, avoiding that the cabling takes on a spiral form which may have inductive effects on the electronic system. All
conductors used in the cabling must be appropriately sized in order to support the load which they must provide. If it is necessary to extend the probes, use conductors with appropriate cross-sections and not less than 1
mm². The extension or reduction of the probes may alter the calibration which was performed in the factory. Therefore, verify and calibrate by means of an external thermometer.
