STEP 3
(See Diagram 3)
A.) Attach the pivot on the Leg Developer Holder (#7) to the open bracket on the Main Seat
Support (#5). Attach the bottom of Leg Developer Holder to the Main Seat Support. Secure
it with one M10 x 2
¾
” Carriage Bolt (#33) from front, one M10 x 2 ½” Allen Bolt (#37) from
rear, two
Ø
¾
” Washers (#41), and one M10 Aircraft Nut (#44).
B.) Attach the Incline Support (#9) to the side-holes on the two Backrest Supports (#8). Align
the holes. Secure it with one M10 x 5 ½” Allen Bolt (#34), two
Ø
¾
” Washers (#41), and one
M10 Aircraft Nut (#44).
C.) Attach the holes on the end of the Backrest Supports (#12) to the bracket on the Main Seat
Support. Align the holes. Secure the two Backrest Supports to the bracket, and the pivot on
Leg Developer Holder together with one M12 x 5
¾
” Hex Bolt (#31), two
Ø
1” Washers
(#41), and one M12 Aircraft Nut (#44).
D.) Do not over tighten the Nuts and Bolts. Make sure the Backrest Supports and Backrest
Incline are able to swivel.
E.) Place the other ends of Incline Support onto the selected slot on Incline Support Frames
(#12) to hold the Backrest Incline in position.
DIAGRAM 3
7
Summary of Contents for WB859
Page 11: ...10...
