Pegasus Technologies, Inc.
PTSS2011Transceiver
Users Manual (Preliminary)
RF Transceiver Installation Instructions
The PTSS2011 Transceiver Frequency Hopping Spread Spectrum transceiver. This transceiver should only
be installed by qualified service personnel. The transceiver detects level, low battery or other data signals
from the external binary inputs and broadcasts that data to the system's host receiver.
MOUNTING LOCATION
The PTSS2011 Transceiver is a module as defined by the FCC and therefore must be mounted to another
host device in order to function.
This device is intended only for OEM integrators under the following conditions:
1) The integrator must position this device in any end product such that the antenna to user/bystander
distance is greater than 20 cm when the transmitter is functioning (excluding hands, wrists, feet and
ankles).
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as the 2 conditions above are met, further transmitter testing will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance requirements
required with this module installed (for example, digital device emissions, PC peripheral requirements,
etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for example applications where
the antenna to user distance is < 20 cm or to be co-located with another transmitter), then the original FCC
authorization is no longer considered valid and the FCC ID can not be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization.
NOTICE TO CUSTOMER
Any Pegasus Technologies customer incorporating the PTSS2011 transceiver module into its own product
must have an external notice affixed to its product. This notice must be placed in a conspicuous location
and can use wording such as: “Contains FCC ID: QLBPTSS2011” or “Contains Transceiver Module FCC
ID: QLBPTSS2011”. Any similar wording that expresses the same meaning may be used.
NOTE: The end user should NOT be provided any instructions on how to remove or install the device.
RF Exposure Manual Information That Must be Included to End User
The users manual for end users must include the following information in a prominent location
"IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for
this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and
must not be co-located or operating in conjunction with any other antenna or transmitter."
