PEGASUS ASTRO
–
FOCUSCUBE V2
| 1.2
16
Position Limits
You can set the maximum & minimum step position that the motor can go. This will enforce the controller to disallow a motor
move to the direction you are about to exceed this limit. This is a handy option to prevent the focuser to fully move in or out.
•
Move to the
Settings
tab and type the numeric limit inside the “Minimum” and “Maximum” field.
•
Click the “ON” to enable these limits.
When you try to exceed this limit the controller will deny to increase steps and it will notify you that the limit was about to
exceed.
Disabled Knob of the Hand Controller
If you would like to disable knob on the side of the controller
•
Press the knob for two (2) seconds.
•
You can also disable it from the settings of the standalone software.
Hand Controller’s both leds
will turn on and the software will report the disabled status of the knob.
Press the knob one more time to enable the encoder functionality
Firmware and Software Version
Useful information about the:
•
Commands exchanged
•
Software version
•
Model of your controller (name and revision of the electronic board)
•
Firmware version
can be viewed on
the “Information” tab.
