WES
Components
90 Paramatta Rd Summerhill 2130
PH
(02)9797-9866
Designed by Russell Storey - Stones Sound Studio - www.wes.net.au
Place your speaker cabinet on a non-slip, non-scratch surface.
Identify the orientation of the box as you desire (Left or Right).
Insert the Amplifier.
The ports are on the bottom side, so make sure you install the
amp upright. Pilot holes are pre-drilled so simply screw in the
supplied screws, caution that you don't thread the screws by
over tightening. If using an electronic screwdriver, adjust to a
medium/high torque setting. Beware which way is UP!
Insert
the
Wadding.
(Ignore as wadding is already installed.)
The
internals
require
some
dampening.
Ensure
you
cover
the
amplifiers
plastic
cover,
but
allowing
the
connection
Apply the gasket tape.
For a good air-tight seal between the speaker and cabinet,
it is required that you apply gasket tape around the whole
circumference of the flange on both of the woofers.
Insert the Passive Radiator.
This is the driver without any magnet. It is mounted on the rear of
the cabinet. Identified as the hole without the feature panel or grill
mounting plugs. Gradually tighten each screw, traversing across
the woofer. Carefully, ensure the wadding does not interfere with
the driver and that the gasket seals tight and proper and you don't
thread the screws or accidentally slip and puncture the cone!
Insert the Speaker.
Cabling is supplied with the amp and will connect directly to the 12" driver.
We highly recommend that you solder this connection for reliability. Make
sure the cable is not going to rattle on the drivers cone. Now simply locate
the driver into the flush hole and apply the screws, again tightening
carefully as not to strip them or slip and puncture the cone.
Passive Radiator
Feature Panel
You may wish to leave this untill after the testing stage.
Please affix the panel carefully with the appropriate
GLUE (Not Supplied) and let dry as per glue
instructions. The front is identified by the grill sockets.
SOLDERING IS RECOMMENDED
APPLYING GASKET TAPE
AROUND THE DRIVERS
IS VERY IMPORTANT !
cable thru. Split the
remains into strips and
place BETWEEN the
bracing battens on the
top, bottom, left and right panels. Don't allow any of the wadding to
touch any part of the drivers. Use a staple gun or appropriate glue.
Affix the wadding to the side of the cabinet, stapling down all
edges and loose areas.
