ISSUED: 08-11-03 SHEET #: 090-9093-3 11-10-04
Visit the Peerless Web Site at www.peerlessindustries.com
For customer service call 1-800-729-0307 or 708-865-8870.
3 of 4
Fasten LCD Assembly (
A
) to cabinet using four
10-32 x 1.25” screws (
D
) four #10 SAE wash-
ers (
I
) and four 1/4” spacers (
E
). Get all four
screws (
D
) started before tightening.
Note:
If cabinet underside has lip, use four 7/8”
spacers (
G
) and four 10-32 x 2” screws (
F
)
instead of screws (
D
) and spacers (
E
). This
lowers LCD Assembly (
A
) by 7/8” to allow LCD
Assembly (
A
) to open and close without
obstruction.
Carefully hold the closed mount with the TV against the
bottom of your cabinet. Make sure that there is enough
clearance between the back of the TV and the wall to
clear the back tab. Drill four 1/4” holes to match the
drawing to the right.
F
E
G
or
or
I
A
Back Tab
6.00”
1.25”
Back holes of
LCD assembly
Locate the bracket in the slot so that
the top of the TV does not touch the
round cover or go above it when the tilt
is in the open position as shown in
figure 1
. Place 1/4 split washer (
L
) on
M5 screw (
K
) before #10 SAE washer
(
I
) and fasten adapter plate (
B
) to LCD
assembly (
A
) as shown in
figure 2
.
Wall
figure 1
TOP VIEW
Sample location: your
screen may mount in a
different location in the slot.
K
A
B
L
I
Round Cover
figure 2
• We recommend taking the screen off the mount to
affix the bracket to the cabinet, to avoid any damages
to the screen.
CAUTION
D
