9
2016-04-21 #:220-9010-4 (2016-08-24)
Replacing Cord Cover
1.
Run cables across foam gasket block. Leave approximately 1/2" (13mm) between cables to
ensure a proper seal.
2.
Replace cord cover (B), (4) thumb screws (D) and (4) retaining washers (E). Fasten thumb
screws until gasket on cord cover plate is fully compressed to back of television. Cables will seal
between display's gasket and cord cover's gasket as cover is pressed into place. Route cables
through opening at end of cord cover.
B
D (4)
E (4)
•
Ensure bend radius limits for cables do not
exceed limits set by the manufacturer.
•
Ensure cables are seated properly in the
cable gland to avoid potential damage to
cables when cord cover is installed.
•
Do not remove lanyard that connects the
cord cover to the display.
CAUTION
Do not overtighten screws
