10 of 12
ISSUED: 08-08-12 SHEET #: 009-9074-1
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket (
F
) into display as
shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE:
Spacers may not be used, depending upon the type of display.
Begin with longer length screw, hand thread through multi-washer, adapter bracket (
F
) and spacer in that order
into display as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into
place. Do not over tighten. If screw cannot make three full turns into the display, select a longer length screw from
the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
For Flat Back Display
For Bump-out or Recessed Back Display
11-2
11-1
If you have any questions, please call Peerless customer care at
1-800-865-2112
.
If you have any questions, please call Peerless customer care at
1-800-865-2112
.
fi g 11.2
SCREW
MULTI-WASHER
ADAPTER BRACKET (
F
)
DISPLAY
SPACER
fi g 11.1
SCREW
MULTI-WASHER
ADAPTER BRACKET (
F
)
DISPLAY
