12 of 16
ISSUED: 08-30-13 SHEET #: 180-9051-1
Step 7
Connect speaker wires to the speaker terminal plug. Strip 3/16” insulation off the speaker wires,
loosen the screw clamp, insert the wire, and tighten screw clamp. Be sure to follow the positive and
negative nomenclature.
Step 8
Take the ADS100-RXS stereo RX module and plug into the port on the ampli
fi
er. Install the M3 phillips
locking screw through the RX module into the ampli
fi
er.
Step 9
The installer will want to leave the amp out of the wall to verify pairing has taken place between the
TX and the RX. Once pairing can be veri
fi
ed, the amp can then be installed in the wall.
Transmitter and Amplifi er Pairing
When pairing the Transmitter Module to the Receiver/Ampli
fi
er, make sure to apply power to the RX
module
fi
rst. The receiving ampli
fi
er needs to be in a powered on state in order for the TX module to
pair with it.
Step 1
Apply power to the ADS100-T8 transmitter by pressing the power button on the front left. The two
right side front-facing LED’s will illuminate red. The audio source(s) should also be powered on, and
connected to inputs 1-4. A portable music player with RCA outputs can also be used also for channel
assignment.
Step 2
Apply power to the ampli
fi
er(s) installed. Ensure at least one or all speakers are connected. Both blue
LED’s will blink every second.
Step 3
At the transmitter face, depress the "SYNC 1-4" button once. The face LED and TX LED will both
blink, allowing 2 minutes to sync to the appropriate ampli
fi
er. This allows any and all 4 inputs matched
to that TX module to be synced. If not synced, resumes previous assignment. The process can start
again.
Step 4
At the ampli
fi
er, press “Sync” button once. The blue LED will stop blinking, indicating it has locked
onto the TX module. If not synced to the input channel desired, press the “CH-SEL” button, and scroll
through the inputs to
fi
nd the correct one(s). LED on transmitter face and TX module will illuminate
solid blue to indicate successful pairing.
Step 5
Repeat the above procedure for additional ampli
fi
ers. Each ampli
fi
er needs to be synced from start to
fi
nish. Return to the ampli
fi
er to
fi
nish the installation, and the instructions step.
