4 of 7
ISSUED: 06-04-10 SHEET #: 120-9083-2 05-14-12
BB
CENTER bRACkETS VERTICALLY
ON bACk OF SCREEN
X
AA
X
HANDLE FACE
OUT
Note:
"X" dimensions should be equal.
NoTe:
For flat back screens proceed to step 1-1. For bump-out or recessed back screen skip to step 1-2.
MULTI-wASHER
MEDIUM HOLE FOR M5 SCREwS
SMALL HOLE FOR M4 SCREwS
LARgE HOLE FOR M6 SCREwS
Notes:
• The number of fasteners used will vary,
depending upon the type of screen.
• Multi-washers and spacers may not be used,
depending upon the type of screen.
• Use the corresponding hole in the multi-
washer that matches your screw size as
shown.
• Slots in ST680 models are wider and require
the use of the M8 washer.
Installing Tilt Brackets
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place
screen face side down. Refer to screen manufacturers instructions or customer service, for removing any knobs,
base, cover or screw(s) on the back of the screen to prepare mounting. These need to be removed to allow the tilt
brackets to be attached. Select the small, medium, large or extra large screws from the baffled fastener pack then
attach tilt brackets to screen following figure 1.1 or 1.2.
NoTe: Top and bottom mounting holes on screen must be used for attaching brackets.
NoTe:
be sure to attach tilt brackets with handles facing outward as shown below. Verify that all holes are properly
aligned, and then tighten screws using a phillips screwdriver.
• Tighten screws so adapter brackets are firmly attached. Do not tighten with excessive force. Overtightening
can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to
become detached.
Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
WARNING
1
