5 of 5
ISSUED: 05-04-10 SHEET #: 120-9078-3 06-10-13
For preset tilt angles use Increlok
™ and for custom tilt angle use ratchet handle.
INCRELOK
™
:
The screen can be locked into a
pre-set tilt position of -5
°
, 0
°
, 5
°
, 10
°
or 15
°
. Use locator hole to fi nd tilt position hole and tilt screen to align holes.
Tighten IncreLok™ tilt locking screws on both adapter brackets to lock tilt as shown in detail 2.
Ratchet Handle:
Loosen ratchet handle (refer to step 3 for tension adjustment of handle).
Push or pull from top
or bottom of screen to adjust tilt as shown in fi gure 3.1. The tilt can be adjusted to a maximum of 15° forward or 5°
backward.
DETAIL 2
fi g 3.1
IncreLok™
TILT LOCKING
SCREW
LOCATOR
HOLE
RATCHET
HANDLE
TILT
POSITION
HOLES
Adjusting the Tilt Angle of the Flat Panel Screen
3
© 2013, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
Screen Adjustment:
Screen can be adjusted horizontally by loosening safety/security screws on adapter brackets
(
AA & BB
) three full turns. Adjust screen as shown in fi gure 2.2. Tighten safety/security screws on adapter
brackets using 4 mm allen wrench (
CC
) till screw tip securely contacts wall plate as shown in cross section.
Removing Screen:
To remove screen from mount, loosen safety screws, swing screen away from mount, and lift
screen off of mount.
fi g 2.2
WALL PLATE MAY APPEAR
DIFFERENT THAN ILLUSTRATED
