e
T
The LOGICFLOW controller is designed to automate the operation of an electric pump by
sensing the water movement in systems that have some flow due to gravity. The
opening of a tap/valve will cause a small flow of water that is detected by the unit and
the pump is started, closing the tap will stop the water flow and the pump stops.
NOTE: For systems that have no or insufficient gravity flow the BRIO2000M
controller should be used.
The unit will also protect the pump from dry running in the event of water supply failure.
To restore normal operation to th edevice and the system simply press the red “Restart”
button. In case of power failure, it will automatically reset again a few seconds after the
electricity returns.
Made from a high quality engineering plastic, it can be used for a variety of
domestic and commercial water-boosting applications providing there is a
positive head.
The LOGICFLOW is designed for use on clean water (if there is the possibility of sediment,
a suitable filter should be installed before the unit).
For correct operation the system must have a minimum height
(or showerhead etc.) at the point of use.
LOGICFLOW controllers are suitable for use in pairs to operate shower
pumps on hot (max 60° c) and cold supplies, subject to the maximum
electrical load (8 amps) not being exceeded. They should be connected
together in parallel.
(See Fig 1 and 2)
Installation
Operation
Dimensions
Wiring
Mechanica
l
It should not be used for any installation where the unit may be subject to more than 8 bar pressure.
Electrica
l
The LOGICFLOW unit should be wired as per the wiring diagram below - is maintenance free and requires no initial
setting up or adjustment.
0
1
543 415200
