Assembly:
The telescopic supports must be screwed to the
side of the footboards from the 6th hole. For each
support insert 2 screws (M8 x 40 mm) through the
footboard holes from above at a distance of 10 cm.
From below, screw on the support lug with 2 nuts
each with washers. Check screws occasionally!
Never use the Pedalo-Reha-Bar S without supports!
Two telescopic supports are each connected at the
top with a bar perforated strip (Unscrew the holding
balls before, the screws are used to fasten the
bars).
The telescopic support is individually adjustable in
height.
Ensure the same height adjustment of the supports.
Last control before starting:
First move the Pedalo back and forth with your
hand. It should be easy to move without striping. It
is possible that a footboard "wedged". This can be
solved by briefly pushing the Pedalo on a wheel
with your foot.
Please check if all wheel nuts are attached and
screwed tight.
richtig
falsch
The advantages of the Pedalo-S Series:
The Pedalo can be rebuilt individually. With a few extension parts, a variety of variants can be achieved.
wheel spacer through spacer
set (5 or 10 cm)
Pedalo-Reha S
Ride-Pedalo
