Copyright ® pedalo by Holz-Hoerz GmbH
Seite/page 4 von/of 4
Stand: 19.5.2020He / _e 15.10.2020PH
Mounting of the rear axle:
First remove the axle cover and the nut +
washer on the push rod. Add grease from the
tube to all the points marked with
Insert the rear axle. Replace the axle covers on
the screws and tighten them.
Fasten the push rod with the rear axle. Tighten
all screws again.
Mounting the drive wheel
The drive wheel is firmly screwed to the rear
axle at the specially flattened point on the rear
axle.
Make sure that the screw hits the flattened spot
on the axle exactly!
On the outer side of the wheel
an adjusting ring is screwed on.
Mounting the freewheel wheels
Add some grease to all freewheels and axles.
Mounting the freewheel rear
wheel
An adjusting ring is screwed on both
sides.
Mounting the freewheel front
wheel
Use a washer on the inside.
A set collar is screwed on the
outside.
Adjusting the front axle
The front axle position can be adjusted depending on the driver's leg length.
To do this, loosen the countered cap nut and remove the screw
(two 13mm wrenches are required)
Then insert screw and front axle into desired new position.
First tighten the first M8 nut firmly until the square of the carriage bolt has completely
countersunk in the axle bearing block. Then loosen the nut again slightly so that the axle
beam can be moved easily.
Finally, the cap nut is screwed on and locked with the first nut.
(this prevents the screws from loosening)
Maintenance and care:
- Retighten all screws occasionally.
- Occasionally regrease all moving parts of the driving mechanism.
- Regrease the wheel bearings from time to time.
- Replace worn parts immediately.
36
36
35
