Holz-Hoerz GmbH
Dottinger Str. 71
D-72525 Münsingen
Tel. +49 (0) 7381 - 9357 0
Fax +49 (0) 7381 - 9357 40
[email protected]
www.pedalo.de
Copyright ® pedalo by Holz-Hoerz GmbH
Seite/page 2 von/of 2
Stand/status: 04.05.2021 He/20210610ph_e
User manual
21080000
Pedalo® Suspension Brackets
Thank you for choosing a Pedalo® product.
So that you can enjoy this product and the safety is guaranteed,
you should read this manual completely before using the equipment.
Keep the manual in a safe place.
We are at your disposal for any questions and requests.
Important information and warning hints:
Warning!
This device is a demanding exercise device! The equipment is to be used with caution, since it requires great skill, so as to
avoid falls or collisions causing injury to the user or third parties. In case doubt first use the device only with assistance and/or
appropriate protective equipment. When used by children, adult supervision is recommended.
Warning!
The packing is not part of the product and have to be disposed.
Keep plastic bags and films out of the reach of babies and young children
– RISK OF SUFFOCATION!
Warning!
The device is only to be used for the purposes described in this user manual.
Worn parts should be replaced by original replacement parts immediately.
The product is made of natural birch or beech wood. Differences in color, structure, grain, small included knots or scars, prove the
genuineness of the material and therefore show no reduction in quality.
Maintenance and cleaning:
Can be wiped off with a damp cloth. Do not use solvent-based, acidic, or abrasive cleaners. Protect item from wet.
Some products are treated with a coating oil approved for toys. It is possible that this may smell for some time after delivery.
This device is meant for using from persons at the age of 6 up. Maximum weight capacity 120 kg
Assembly:
Connect one Suspension Bracket's upper part to one Suspension
Bracket console each. Insert two cross-hole nut bolts into each of the
Suspension Brackets. Make sure that the slot in the cross-hole nut bolt
faces the edge of the board. Now screw both parts together with two
continuous M8x60 mm screws. Use a washer for each screw. Tighten
the screws firmly. Now insert the pad for the armrest into the recess of
the Suspension Bracket's upper parts. This can also be easily removed
again for cleaning.
Mounting at 'Wall Bars':
The wall bars must be designed for a load of at least 120 kg. We
recommend our wall bars (item no. 181 50240). Hang the Suspension
Bracket at any height with the notch in the upper part into a rung. The
distance can be adjusted by moving the Suspension Brackets on the
wall bars.
To protect the wall bars, you can also glue a felt glue dot to the rear
edge of each dip bracket at the lowest contact point.
Accessory:
Pedalo® Trainings Stick
(item no. 144 140).
This stick can be used as a pull-up bar by inserting it into the drill holes
of the suspension brackets.
