Peco Pro 12 DFS 37621231, Operator'S Manual

Page: 12 / 32

12
Loosen the (4) bolts P#(K1191), (2) on each side, that
secure the gear box assembly to the PTO assembly
P#(A0623) (Figure 2-12a and 2-12b).
PTO MODELS ONLY
2-12 Belt Installation and Adjustment
Loosen the adjustment bolt P#(K0348) until the gear box
assembly is at its far left adjustment (the gear box is
moved toward the mower’s engine pulley). Refer to
Figure 2-12c.
Connect the belt A55K P#(M0248) from the engine
pulley to the lower gear box pulley (Figure 2-12d).
To tension the drive belt, turn the adjustment bolt
clockwise (Figure 2-12e) until there is 1” of deflection,
with 10-11 lbs. of pressure, at the center of the belt
between the engine pulley and the gear box pulley.
Once the correct tension of the belt is achieved, tighten
the (4) bolts that secure the gear box assembly. Refer to
Figures 2-12f and 2-12g. Replace the belt guard and
hardware that was removed in Section 2-11.
Loosen Bolts
Figure 2-12a
Figure 2-12b
Loosen Bolts
Figure 2-12c
Loosen The
Adjustment Bolt
Slide Gear Box
Towards The
Engine Pulley
Connect Belt
To Both Pulleys
Figure 2-12d
Figure 2-12e
Figure 2-12f
Figure 2-12g
Tighten Bolts
Tighten Bolts
Tighten The Adjustment
Bolt To Tension The Belt