Peavey PCX-U302, Operating Manual

Page: 12 / 28

d. If the receiver output level is adjusted to a
level that is near the maximum input level of
the desired device, it will cause saturation
distortion of the device when the receiver
output level is increased due to a increase in
level by the sound source. Conversely, S/N
ratio will decrease if the receiver volume
control is adjusted too low.
5. Plug the cable of the mains unit into DC
socket on the receiver’s back panel. Thread
the cable through the cable grip as shown in
the figure below (Figure 10). The cable grip
prevents the connector from being pulled off
by accident.
Fig. 10
5. Caution
1. Since the installation of the antenna influences
the operating efficiency of the receiver, the
most important rule is to minimize the distance
as much as possible between the receiving
antenna and the microphone for the best
reception and performance.
2. The output voltage of the external DC power
supply should not be below 12V, otherwise it
will not work properly. If the voltage is over
15V some components of the receiver will be
damaged due to excessive current draw. Use
a power supply with a 1A minimum rating.
12