Peavey IRM 8150, Owner'S Manual

Page: 5 / 16

5
TAPE/AUX TO MON (14)
Controls the level of tape or AUX IN signal to be sent to the mon. bus. This signal will be mixed with channel
monitor signals.
TAPE OUT/TAPE IN: CAUTION
Before placing connected tape decks in the "record" mode, set the TAPE/AUX IN level control to "0" or off.
Most tape decks feed the input signal directly to the output when in record mode. This creates a "closed loop"
condition from the tape out to tape in jack which can affect the operational level or sonic quality of the system
and cause feedback.
TAPE IN (RCA TYPE) JACKS (15)
These two jacks provide a paralleled input for proper mono mixing of stereo tape deck outputs. For monaural
tape sources, use either jack.
TAPE OUT (RCA TYPE) JACKS (16)
These two jacks provide the same monaural signal to be supplied to the left and right inputs of a stereo tape deck.
Output level is determined by the TAPE OUT (12) level control.
REAR PANEL INPUT/OUTPUT SECTION:
BALANCED LOW IMPEDANCE INPUT (17)
For use with low impedance microphones or low-level sources equipped with an XLR connector.