background image

 

FCC/ICES Compliancy Statement 

This device complies with Part 15 of the FCC rules and Industry Canada license-exempt RSS Standard(s).  Operation is 

subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must 

accept any interference received, that may cause undesired operation. 

Le présent appareil est conforme aux CNR d’lndustrie Canada applicables aux appareils radio exempts de 

licence.  L’exploitation est autorisée aux deux conditions suivantes: (1) I’appareil ne doit pas produire de 

brouillage, et (2) I’utilisateur de I’appareil doit accepter tout brouillage radioélectrique subi, même si le 

brouillage est susceptible d’en compromettre le fonctionnement. 

 

Warning:

 Changes or modifications to the equipment not approved by Peavey Electronics Corp. can void the 

user’s authority to use the equipment. 

 

Note –

 This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against 

harmful interference in a residential installation.  This equipment generates, uses, and can radiate radio 

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 

interference to radio communications.  However, there is no guarantee that interference will not occur in a 

particular installation.  If this equipment does cause harmful interference to radio or television reception, 

which can be determined by turning the equipment off and on, the user is encouraged to try and correct the 

interference by one or more of the following measures. 

 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and receiver. 

Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

Consult the dealer or an experienced radio/TV technician for help. 

 

 

Caution 

The equipment complies with FCC radiation exposure limits set forth for an uncontrolled 

environment. 

 

 

Summary of Contents for 6505 II










Reviews: