Key Bolt
Anchor Screw
Allen Screw
Hoop Clamp
Fig.8
Fig.9
Fig.10
Wing Bolt
Adjustment Knob
Toe-Stop
Footboard Angle Adjustment
To adjust the footboard angle, remove beater and loosen
Key Bolt on the Drive Connector as shown (Fig.5). Slide the
Drive Connector of the Chain or Belt to one of three
positions, tighten the Key Bolt and replace beater.
Fig.5
Spring Tension Adjustment
The P-2052C / P-2052B Pedal features our patented Click
Lock spring tension retention system. To adjust the spring
tension, disable the Click Lock by lifting the lever upward
(Fig.6-B) and loosen the Upper Nut shown in (Fig. 6-A). To
increase spring tension, turn the Lower Nut clockwise. To
decrease spring tension turn the Lower Nut
counter-clockwise. Once desired spring tension is
achieved, tighten the Upper Nut against pedal frame firmly.
To secure the setting, lower the Click Lock lever to engage
the grooves around the Lower Nut until you feel the lever
"Click.” Before playing, make sure that both Upper and
Lower Nuts are tight and the Click Lock lever is in a vertical
position with both sides of the lever engaged in the grooves
around the Lower Nut (Fig.7).
Recommended for carpeted surfaces only. Use on hard flooring
may result in damage to the surface from spikes. Check to ensure
spikes are retracted when used on these surfaces.
CAUTION
If the heel of the pedal lifts while playing, loosen the Adjustment
Knob to change the angle of the Hoop Clamp until the pedal
remains flat.
Note
Removable Toe-Stop
The Toe-Stop may be removed
for individual playing style. To
remove simply unscrew Key
Bolt and remove Toe-Stop
from footboard (Fig.8). Store in
secure location for possible
future use.
Anchor Screw
To prevent the bass drum from
creeping forward while playing
turn the Anchor Screws
clockwise to extend the spikes
downward into the floor
(Fig.9).
Hoop Clamp system
To attach your pedal to the bass drum, slide the bass drum
hoop between the Hoop Clamp and the bottom lip of the
pedal. Square the pedal and tighten the Wing Bolt to
secure the pedal to the bass drum hoop. The Hoop Clamp
system is fully adjustable and comes preset from the
factory to accommodate a variety of hoop thicknesses. To
adjust, use the hexagonal wrench provided to loosen the
Allen Screw on the side of the Adjustment Knob. Rotate the
Adjustment Knob until proper fit is achieved then tighten the
Allen Screw to secure setting (Fig. 10).
Drive Connector
Key Bolt
Spring
Upper Nut
Lower Nut
Click Lock
Fig.6-B
Fig.6-A
Fig.7
