Fig.2
Fig.3
Fig.4
Fig.5
Die-Cast Joint
Movable Leg
Lower Bracket
Rubber Tip
Wing Nut
Wing Nut
Stable Leg
Stopper
Upper
Bracket
Wing Bolt
Base Section Assembly (Fig.1)
a) Using on Flat Surface (As shown in Fig. 2)
1. Loosen the Wing Nuts on the
Stoppers of the Stable Legs.
2. Slide the Stoppers to the end
of the Legs to the Rubber Tip,
and tighten the Wing Nuts.
3. Loosen the Wing Bolt on the
Upper Bracket of the Movable
Leg.
4. Slide the Upper Bracket up
and adjust the position until
the base stands straight up,
and tighten the Wing Bolt.
Top Section Assembly (Fig.5)
1. Loosen the Wing Nut of the Die-Cast Joint of the Base.
2. Insert the top section as shown, and tighten the Wing Nut
and the Key Bolt on the Stop Lock.
b) Using on Uneven Surface (As shown in Fig. 3)
1. Loosen the Wing Nuts on the
Stoppers of the Stable Legs.
2. Slide the Stoppers to the end
of the Legs to the Rubber Tip,
and tighten the Wing Nuts.
3. Loosen the Wing Bolts on the
Upper and Lower Bracket of
the Movable Leg.
4. Slide the Upper Bracket to the
top of the pipe, and tighten the
Wing Bolt.
5. Slide the Lower Bracket and
adjust the position until the
base stands straight up, and
tighten the Wing Bolt.
Fig.1
Note
If the distance between the Rubber
Tip of the Movable Leg and the
center of the pipe becomes shorter
than 30 cm, slide both the Upper
and Lower Bracket and adjust their
positions. Make sure to adjust the
position so that the base stands
straight up. (Fig. 4)
Note
・
For height adjustment, loosen the Wing Bolt on the Die-Cast Joint
and the Key Bolt on the Stop Lock, and slide the Top Section.
Tighten the Wing Bolt on the Die-Cast Joint and the Key Bolt on
the Stop Lock when desired height is achieved. Do NOT make
height adjustment with the Snare Drum mounted on the stand.
Top Section
Die-Cast Joint
Wing Nut
Key Bolt
Wing Bolt
Key Bolt
Stability Arm
Stop Lock
Support Bumper
Snare Arm
