– 7 –
–
1. Remove the water pump from the box and
check that it is not damaged.
2. Place the pump within the water tray such that
the water outlet is horizontal. (see figure 2)
3. Connect the water hose from the blade guard to
the pump and plug the pump’s power cord into
the receptacle on the switch box.
4. Fill the water tray so that the water intake is fully
immersed. Proper water level must be
maintained at all times during saw operation.
WARNING: Disconnect the pump before
attempting to handle the pump. Never
operate pump without water in the tray.
1. The ruler guide is made of a thick rigid steel to
promote accurate straight cuts. (See figure 3)
2. With the tables broad surface area able, the
cast aluminum table spans an area of 14-in x
15-in, able to support up to 20-in tiles.
3. Cutting table is covered by a rubber mat that
provides a firm, durable work surface.
4. A rip guide should be used together with the
cutting table to ensure precision while making
cuts.
1. Set the rip guide at the desired location on the
ruler guide and tighten the threaded knob.
Make sure that the rip guide is firmly tightened
to avoid slippage. The rip guide can be used for
45˚ and 90˚ cuts. (See figure 4).
2. After the rip guide is positioned for the desired
cut, place material flat against the rip guide and
the ruler guide.
3. Now you are ready to make your cut.
1. Remove threaded knob from the end of the rip
guide with the horizontal groove and insert it
into the other end with the diagonal groove.
(See figure 5).
2. Set the rip guide onto the ruler guide, such that
the top edge of the rip guide is aligned with the
diagonal groove to the left of the vertical
channel in the cutting table. Tighten threaded
knob once in place.
3. Place one corner of the material being cut in the
vertical slot of the ruler guide and rest the
adjoining edge flat against the rip guide.
4. Now you are ready to make your cut.
To make miter cuts, an optional miter block must
be purchased.
1. Place the lip of the miter block on the ruler
guide with the threaded knob facing you.
2. Position the miter block such that a tile laying
flat against the block may rest its left-most
edge within the vertical channel of the cutting
table. Tighten the threaded knob to secure the
miter block in place.
3. Place material onto miter block and you are
ready to cut.
Figure 2
Figure 3
WATER PUMP INSTALLATION
USING THE RIP GUIDE
PERFORMING DIAGONAL CUTS
PERFORMING MITER CUTS
USING THE CUTTING TABLE
Figure 4
Figure 5
Figure 3
