To help preserve the life of the laminator rollers, please take one of the following actions when you have finished using the system.
Set the temperature to a reading below 60
o
C and allow the rollers to continue turning until cool (the top of the laminator should feel
cool). When you have finished laminating, continue to let the laminator run at a low temperature and feed through a piece of card,
stopping it half way through.
Error warnings
If the LED display reads OPN, ALR or CLS there is a fault with the temperature sensor. Turn off your system and do not use it until you
have contacted your supplier for advice.
Warranty & Incorrect Use
Your laminator should reach you in perfect condition, however please retain all original packaging once you have unpacked your laminator in case you need to
return it. If your laminator arrives damaged or faulty in anyway, this must be reported to your supplier immediately. If you send your laminator back for repair
under warranty at any time, then the warranty may be void if the laminator is not packaged correctly and as a result is damaged in transit. Unauthorised repair
or attempts to service the unit will invalidate the warranty. All Peak Pouch Laminators include a 1 year warranty on defective parts under normal operating
conditions. THIS DOES NOT COVER any jams, misfeeds or wrap arounds caused by operator error and you will be liable for the repair costs (including delivery
charges). The warranty does not cover the heated rollers. The warranty is for a period of one year from the date of purchase by the original consumer.
Please note that attempting to laminate any type of unsuitable documents (for example multiple cutouts, textiles, food matter, documents exceeding the
maximum thickness or documents too large or small for the pouch) may result in jamming. Damage caused by incorrect use or failing to follow the instructions
are not covered within the warranty.
FAQs
My document has come out cloudy - what does this mean?
This means that the temperature setting is not quite hot enough. Try increasing the temperature by 5
o
C
and try again as applying
more heat should fix the problem.
My document has come out wavy - what does this mean?
If the document comes out with a wavy finish the temperature is set too high. Decrease the temperature by 5
o
C
and try again. If you
have an important document to laminate such as a photograph, it is always good to try a test document first to ensure you have the
laminator at the perfect temperature.
Safety!
.
Always remember to switch your pouch laminator off after use. Leaving it on for long periods can cause damage
to the laminator and is a health and safety hazard
.
Always put the sealed end of the pouch or Lifejacket® into the laminator first
.
NEVER
laminate metal objects such as keys or coins
.
NEVER
use the laminator near water and do not leave the laminator next to a hot area such as a radiator
.
Always wrap the power cord around safely after use and do not leave it dangling where it could cause an accident
.
Do not allow children to use the laminator, unless supervised
.
If your laminator stops working, do not try to fix it yourself by disassembling the system. Contact your supplier for advice
.
Do not operate the laminator if the power cable is damaged in any way
.
Do not use this appliance for anything other than it’s intended purpose
Technical Specifications
Laminating speed:
300 - 2000mm/minute
Laminating width:
330mm
Maximum pouch thickness:
500 micron
Laminating temperature:
60-160
o
C
Warm up time:
5 minutes
Power supply:
AC 110, 220V/50Hz, 60Hz
Power consumption:
1150W
Dimensions:
550 x 310 x 150mm
Weight:
14Kg
Warranty:
1 year
