How to use your laminator
Ready light
Power switch
Temperature
control
Forward/Reverse
switch
Heater/Cold
switch
Parts and Features
Diagram 1
! This laminator is designed to be used with a card carrier or Lifejacket® and must not be used without one as
this can cause potential jamming and damage.
1) Carefully remove the laminator from all of its packaging and place it on a flat, level surface. Make sure you
keep the original packaging somewhere safe (in case this is needed in the future).
2) Unpack the power cable and insert it into the power outlet at the back of laminator. Plug it in to a power
socket. Press the Red POWER switch to turn the laminator on. The light will illuminate.
3) Check that the FWD/REV (Forward and Reverse) switch is set to FWD (See diagram 1).
4) Refer to the temperature chart and set the laminator to the required temperature (Use this chart as a guide only).
5) Set the HEATER switch to ON.
6) The laminator will now begin to heat. Once it has reached the set temperature, the green READY light will illuminate.
7) Place the document you are laminating inside the pouch, making sure that it is centrally positioned and that a small
border (approx 5mm) is left around the edge. If you are laminating cut-up pieces ensure you still leave a 5mm border.
8) Once the document (or small pieces) are positioned in the pouch (and are not overlapping or touching each other)
then place the document and pouch inside the card carrier or Lifejacket®.
ALWAYS USE A CARD CARRIER OR
LIFEJACKET® WITH THIS LAMINATOR.
Insert the prepared document into the laminator. Make sure you insert the
SEALED EDGE FIRST and do not insert at an angle. The item will automatically feed through and appear the other end.
!
Pay attention as you laminate and watch for your document appearing out of the exit at the back of the laminator. If
you do not see the document appearing after several seconds, press the REVERSE switch to avoid a potential jam and
the document wrapping around the rollers (Although this very rarely happens when using a card carrier/Lifejacket®).
!
When you see your document appear at the exit, do not tug or pull at it to remove it quicker.
9) To turn off the laminator after use, set the HEATER switch to OFF and allow the laminator to still run for 5 minutes
(you will hear the rollers turning). This allows the laminator to cool down and it is then safe to turn OFF.
Thank you for purchasing the Peak educator PE-452. Peak laminators are designed to give you professional,
high quality results, quickly and easily. Please take a few minutes to read through this important document
as any
damage caused to your laminator by user error is not covered under warranty.
x
x
Don’t overlap
Leave a 5mm border
Don’t laminate open
end first
