Peak PAC Auto PAC 300, Operation Manual, Page: 27 / 189

- 21 -
(3) How to adjust LS3, LS2
Figure 1: LS-3 Home Position Figure 1-1
Figure 1: LS-2 Figure 2-1
Figure 1 shows the correct position for LS3 Proximity Sensor
○
31
and the Limit Switch
Cam
○
32
while the machine is in home position.
The machine will stop as soon as the LS3 Proximity Sensor
○
31
detects that Limit Switch
Cam
○
32
is activated. At this time, the Cam Follower
○
41
must stop at the corner
position on the Tension Cam
○
42
as shown in figure 1-1 . If not, please adjust according
to the following instructions.
Adjustment
If Cam Follower
○
41
stops before the correct position:
a. Loosen the two M6 screws and turn the Cam Roller slightly clockwise, then tighten
the M6 screws.
b. Reset the machine and allow it to cycle again to ensure that the Cam Follower
○
41
stops at the correct position.
c. If the problem has not been eliminated, please repeat the "Step One" until the Cam
Follower
○
41
stops at the correct position.
M6 screw
Cam Follower
Tension Cam
Take-up
Feeding
Cooling Time